SECTION 1:DESCRIPTION***********************************************************
Melt-blown cloth electret device is an electrostatic device developed and produced by Kapal Company to generate static electricity on the surface of objects.
Melt-blown cloth electret device is composed of an electrostatic electret rod and a high-voltage device. The high-voltage device provides negative high voltage to the electrostatic electret, and the electrostatic electret emits negative electricity and then charges the object (workpiece) (artificially charged). The higher the voltage, the larger the effective range.
Meltblown cloth electret devices are widely used in industrial production (filming, meltblown cloth, painting, flocking, sorting) and scientific research.|
SECTION 2:FEATURES***************************************************************
Small volume; Easy to install; Smooth work.
SECTION 3:SPECIFICATIONS*******************************************************
| Input voltage |
220VAC 50-60HZ |
| Max power consumption |
60VA |
| Output voltage |
0--50KV |
| Positive rationality |
Negative(N) |
| High voltage output interface |
2 |
| The length of the bar |
600MM |
| External control interface |
3-pin aviation plug |
SECTION 4:PRODUCTS DIECRIPTION**********************************************************
High voltage device
1. The output voltage of the high-voltage device should not be adjusted too high first, and should be gradually increased from small to large to meet the requirements. Adjusting the voltage too high not only wastes electricity, but also poses a safety hazard.
2. The high-voltage device is equipped with a large-capacity capacitor. When the high-voltage device starts, it takes a certain time (<3 seconds) to charge, and the output voltage can reach the rated value. Similarly, after the high-voltage device is shut down, it will take a certain time for the output voltage to drop to "0". When overhauling the electrostatic electret, the discharge needle can be touched only after the machine has been shut down for a sufficient time or the static electricity of the transmitter has been discharged to the ground with a wire.
Electrostatic electret
1. The discharge needle of the electrostatic electret should be kept away from the metal mounting bracket of the transmitter, preferably with insulating material
Make a stand.
2. In order to add enough static electricity to the material, there must be a piece on the back of the electrostatically charged material.
A flat "metal pallet" or "metal screen". This metal pallet is connected to the "earth", that is, the working ground of the DC high-voltage device, so that electrostatic discharge can form a "loop".
3. In order to add enough static electricity to the material and it will not leak (run away) soon after adding static electricity.
It is required that the larger the insulation value of the material, the better. The drier the material and ambient air, the better.
4. It is best not to discharge the electrostatic discharge needle against the bare metal pallet, that is, the surface of the electrostatically charged material.
3. The product is equal to the area of the metal pallet. If the electrostatically charged material changes due to the area size, but the area or length of the electrostatic emitter cannot be changed, it is best to put a thicker insulating material on the bare metal pallet to cover it, or put the The discharge needle of the pallet is managed to cover it, which is conducive to the concentration of the charge on the material that needs to be electrostatically charged.
SECTION 5:APPLICATION************************************************************
SECTION 6:KAPPER NEW FACTORY*************************************
SECTION 7:CERTIFICATES******************************************************
SECTION 8:KAPPER STYLE***********************************************
Audited Supplier 
){kind=link}
){kind=link}